Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-06-2001, 09:30 PM
|
#1 |
|
Registered Member
Join Date: Jun 2001
Location: Irvine, CA, USA
Posts: 7
|
Pinout on O2 Sensor
Hello Technical Geniuses,
I just joined the Forum & hope you wonderful folks can help. I just acquired a Bosch O2 Sensor w/OEM connector to hook up to my new Autometer Air/Fuel Meter. From the Front, the connector looks like: . . . when the clip is at the top. Two white wires go to the top pins, & a black wire go to the bottom pin. Which is the signal, heater, & ground? My manual's on loan, PLEASE help! I'm using a 3rd sensor, so as to not interfere w/the signal to the EFI. TIA, Larry |
|
|
|
06-06-2001, 09:59 PM
|
#2 |
|
Registered Member
Join Date: Jun 2001
Location: Irvine, CA, USA
Posts: 7
|
Please help! See my prev post re: my question. If only I hgadn't lent out my shop manual, dagnabit.
I gotta put everything back togethr, so I can get to work tomorrow! Thnx! Larry '92 5.0 ; Paxton SC |
|
|
|
|
06-06-2001, 10:11 PM
|
#3 |
|
Registered Member
Join Date: Mar 2001
Location: San Diego, CA, USA
Posts: 86
|
The first dot is power gnd. second dot is to ignition run . .
and buttom dot goes to the computer - pin 43 for LH sensor, pin 29 for sensor RH hope this helps |
|
|
|
|
06-06-2001, 10:22 PM
|
#4 |
|
Registered Member
Join Date: Jun 2001
Location: Irvine, CA, USA
Posts: 7
|
Thnx Slider!!!
Let me get this straight, so I don't mess up. The drawing I made, didn't come out like the connector layout since the extra spaces for the bottom dot didn't appear. Looking at the sensor connector w/clip at the top: Left White wire: Power for heater Right White Wire: Ignition On Bottom Black Wire: Engine Computer Thnx again! Larry '92 5.0; Paxton SC |
|
|
|
|
06-06-2001, 10:40 PM
|
#5 |
|
Registered Member
Join Date: Jun 2001
Location: Irvine, CA, USA
Posts: 7
|
Tough crowd.
But I guess it's not the most interesting topic. -Larry '92 5.0 ; Paxton SC |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I got a free mass air sensor | stevstum | Windsor Power | 2 | 05-27-2003 12:50 PM |
| Whats the best way to tell if your running lean or rich? | K.C. 5.0 | Windsor Power | 9 | 09-10-2001 03:04 PM |
| Sensor on Top of T5? | Green92LX | Windsor Power | 13 | 07-29-2001 10:11 PM |
| Temp sensor question | RB92GT | Windsor Power | 2 | 06-23-2001 12:23 PM |
| MAF Sensor Location | Mike Mileski | Windsor Power | 3 | 06-12-2001 11:10 PM |