MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Classic Mustangs
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 04-04-2004, 06:24 PM   #1
orlowted
Registered Member
 
Join Date: Oct 2003
Location: Fleetwood, PA
Posts: 177
Default Front End Wobble

Hello all...I have posted my problem about the front end wobbling when I apply the brakes. I am happy to report that because of all the suspension upgrades (rear anti sway bar, subframe connectors, traction bars) that the rear is doing fine and the car rocks....Problem is that it moves so fast and so nice (true to the road) that when I apply the brakes it just starts to shake in the front end. I have added new Upper and Lower control arms, new drum brakes and most of the front suspension is New. I am gasping for air here....I just purchased new 1" lowering springs for the front and while I am at that task - I want to eliminate the wobble. Here is my thought. Spindles seem OK - Brakes are tight and rest of suspension seems really good....What about the Inner and Outer Bearings????? They are from the donor car. Do you think they could be letting the front end wobble? I am going to get new ones just to rule out the possibility. I just do not know where to go from here. Any suggestions would be really appreceiated.

TJ
orlowted is offline   Reply With Quote
Old 04-10-2004, 06:23 PM   #2
orlowted
Registered Member
 
Join Date: Oct 2003
Location: Fleetwood, PA
Posts: 177
Default Nope - Didn't fix it...

Well - I replaced the bearings in both wheels...What fun, but it did not fix the wobble. Car runs straighter though so it was not a waste of time...Front end seems tighter. I have front drum brakes and the one drum on the passenger side has a chunk about 1/2 deep and about an inch long missing from the inner part. Does anyone think this might be causing the wobble when the brakes are applied. I am running out of Ideas and parts to replace (except the Disk Upgrade)...
TJ
orlowted is offline   Reply With Quote
Old 04-11-2004, 05:29 AM   #3
KiltedBanshees93GT
Registered Member
 
KiltedBanshees93GT's Avatar
 
Join Date: Jun 2000
Location: Pigeon Forge Tn
Posts: 611
Default

Does it seem to pull more in the direction of the side with the missing chunk?
Have you tried getting the front end off the ground and then pulling/shaking the tires both up/down and left/right to see if theres any play in the suspension?
Just an idea, I'm guessing here

J
__________________
____________
'66 Mustang Coupe- AKA "Lenore" *on disability for a (long) bit*
'93 GT Mostly stock AKA "Fawkes"
Rice Haters Club Member #239

"I find your lack of faith...disturbing."

"Every normal man must be tempted at times to spit on his hands, hoist the black flag, and begin to slit throats." H. L. Mencken
KiltedBanshees93GT is offline   Reply With Quote
Old 04-11-2004, 07:18 AM   #4
orlowted
Registered Member
 
Join Date: Oct 2003
Location: Fleetwood, PA
Posts: 177
Default I Tried the basics.

I wish it pulled - then I would have a place to start....Drives straight as can be. When I brake - I am not sure if it favors one side, It wobbles so much that I didn't want to let go of the wheel. I will give that a try and see if it does go to one side...Thanks!

I have had the car up in the air about 10 times pulling, yanking, shaking just about every peice under there. Everything seems tight. I am at the point where I am going to get a wireless camera and tape it to the bumper so I can actually see ehat is going on. I even had my mechanic look at the suspension, brakes and tires and he said everything is as it should be. Disk brakes are in the future, but not till this winter and I wanted to get some pleasure driving out of the car before winter comes. Thanks for the suggestions...I just might try the camera if I can find one...I also might replace the drum if I can gind a good used one here...
TJ
orlowted is offline   Reply With Quote
Old 04-11-2004, 08:34 AM   #5
forease
Registered Member
 
Join Date: Jan 2002
Location: West Virginia
Posts: 15
Lightbulb

How is the control valve ball stud?
forease is offline   Reply With Quote
Old 04-11-2004, 03:24 PM   #6
orlowted
Registered Member
 
Join Date: Oct 2003
Location: Fleetwood, PA
Posts: 177
Default I think it is OK

When I replaced the power steering with the manual kit - it seemed OK. Is there a way to check it???
orlowted is offline   Reply With Quote
Old 04-14-2004, 02:23 PM   #7
orlowted
Registered Member
 
Join Date: Oct 2003
Location: Fleetwood, PA
Posts: 177
Talking Problem Solved

Just wanted to update anyone that may be having a similar problem....Just had the drum brakes turned...Problem is Gone - Works like a dream now.
TJ
orlowted is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
front end feels a little "loose" Simi Stang Windsor Power 4 04-29-2004 08:23 AM
Front end wobble with drum brakes orlowted Classic Mustangs 9 11-01-2003 06:10 PM
Front spoiler kits?2000GT Stac Modular Madness 3 02-27-2001 07:09 PM
Front End: Repair or Replace ttremblay Blue Oval Lounge 3 01-31-2001 10:18 PM
Need new front tires... suggestions... FivepointOH Windsor Power 4 01-01-2001 11:20 PM


All times are GMT -5. The time now is 08:09 AM.


SEARCH