MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 08-27-2001, 08:47 PM   #1
jerryIII
Guest
 
Posts: n/a
Question Temp Guage, going crazy, your opinions... (long)

Got my car together yesterday, test drove it 20 miles, ran great, temp stayed at about 190+...

Started the drive to work this morning, about 10 miles in the city then about 15 miles highway at about 60-70.... Temp guage (aftermarket)stayed at 190 the whole way with a 160 stat, then shoots up to max and car overheats..

let cool, and check the radiator, fill with anti-freeze (thinking maybe an air pocket in the system or ??? took about a 1/4 gallon).. started driving again, 10 more miles, temp stayed at 190, then max's the guage, and overheats.. Luckily I was near my father-in-law's house..

Replaced the radiator with new, checked the timing (12 BTDC), new radiator cap, replaced bypass hose (other one was kinked), new temp guage and installed a 190 thermostat..... Drove it 25 miles guage never went above 210, stopped in town at a light, guage shot to max, then when i started driving, it dropped to 200... made it the 6 more miles to home, and this happened one more time, guage shoots to max then drops back down to about 200....

nothing in the oil, no smoke....

anybody have any ideas, thinking of pulling the heads to see if maybe i screwed up installing the gaskets???? both guages shot up so far the needles are stuck at 150...

------------------
Black,84 GT,ground effects,shorty headers, 'open' dual exh.,302 HO(no pollution control crap)bored .060, 10.5" clutch, T5,89 ported heads, edelbrock Performer manifold, Edelbrock 2122 cam, 600 Holley, high volume oil pump, front P235/60/R15's, rear P245/60/R15's.....

Some day (3:73 gears & N2O)!!!

will this ever end????
  Reply With Quote
Old 08-27-2001, 11:14 PM   #2
Five0
Registered Member
 
Five0's Avatar
 
Join Date: Apr 2000
Location: middleburg, fl, usa
Posts: 1,134
Post

Do you have under drive pullies because when I pulled mine off the temp went from running at 210 while driving and overheating when in traffic to 150 driving to 165 in traffic?

You may also have a bad clutch fan but 210 while the car is moving is high.


------------------
James Cox
nochevy@hotmail.com
1991 Mustang LX
12.565 @109.38mph 1.764 60ft
Five0 is offline   Reply With Quote
Old 08-28-2001, 08:41 AM   #3
jerryIII
Guest
 
Posts: n/a
Unhappy

No pullies, thats why this is so frustrating, sometimes it will be ok for 30 miles then the temp goes crazy or it'll happen in 5 miles.......


Grrrrrrrrrrrrrrr

------------------
Black,84 GT,ground effects,shorty headers, 'open' dual exh.,302 HO(no pollution control crap)bored .060, 10.5" clutch, T5,89 ported heads, edelbrock Performer manifold, Edelbrock 2122 cam, 600 Holley, high volume oil pump, front P235/60/R15's, rear P245/60/R15's.....

Some day (3:73 gears & N2O)!!!

will this ever end????
  Reply With Quote
Old 08-28-2001, 01:29 PM   #4
fiveohpatrol
I'd rather be basketweaving
 
fiveohpatrol's Avatar
 
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
Post

im guessing its a head gasket, as this is the same thing that happened to me

did you see the markings on the head gaskets that said "front" on them? if they're turned around, water wont be able to flow properly

i know you said theres no coolant in the oil but it is sometimes hard to see, i couldnt tell by looking at the dipstick but i let the car sit then drained the oil to see about 1/2 gallon of pure coolant came out before ANY oil came out, i guess oil and water REALLY dont mix

good luck with it

------------------
88 Notch, B&M Ripper, 3.73's, Ported E7's, Explorer int. w/ ported lower, pulleys, 1.7RR's, BBK headers, off-road H-pipe, flowmasters, subframes, 65mm TB, March ram air ,MSD coil, U/L control arms, 155lph f/p, Crane Adj.FPR, Nitto drag radials, best 1/4--> 13.76@101.4 on a 2.17 60ft
fiveohpatrol is offline   Reply With Quote
Old 08-28-2001, 03:54 PM   #5
Mr 5 0
Conservative Individualist
 
Mr 5 0's Avatar
 
Join Date: May 1997
Location: Wherever I need to be
Posts: 7,487
Lightbulb

Hows the water pump? It could be failing.
I had a new (rebuilt) pump go bad in two days.

Just a thought.
Mr 5 0 is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Detonation + High Temp richd Windsor Power 9 10-13-2001 02:15 AM
Opinions on wheels(kinda long) 1BAD89 Windsor Power 1 06-25-2001 07:05 PM
Temp sensor question RB92GT Windsor Power 2 06-23-2001 12:23 PM
BBK one-piece flange or MAC individual flange long tube headers. Fox Body Windsor Power 10 04-03-2001 04:25 PM
billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) beefcake Blue Oval Lounge 2 02-23-2001 03:05 PM


All times are GMT -5. The time now is 07:23 AM.


SEARCH