![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Nov 1998
Location: Kettering, Ohio
Posts: 119
|
![]() Not sure if I should put this here or not but here goes. I just picked up some 86 Taillights from a guy and I put them in and they look great, but they don't seem to be the same size as my old cheese graters that were in my 90. When the hatch is closed it overlaps the taillights a little bit, not a whole lot but enough that I notice when I look at the car. Did I mess up and get the wrong kind of 86 Taillights? Are the lights different sizes if they came out of a coupe or hatchback? I didn't even think to ask.
![]()
__________________
xspeed02 1990 Black Mustang GT 5spd |
![]() |
![]() |
![]() |
#2 |
Moderator
Join Date: Mar 2001
Location: Myrtle Beach SC
Posts: 1,643
|
![]() Im not sure about the sizing. I had 89 tail lights in my 86 for a while.. When I bought the car the 86 lights were jacked up so I got some 89's from a bud to run temporary like.. Fit fine.. Not sure what to tell ya.
Bradley
__________________
1990 GT, 347, TFS TW Heads, TFS Cam, TFS Track heat, Twin turbos, FMIC, T5. Built Ford Tough Moderator |
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Jun 2001
Location: butler pa
Posts: 303
|
![]() did you replace the whole housing or just swap lenses i just swaped the lenses and dont notice any diff
__________________
92lx wannabe saleen |
![]() |
![]() |
![]() |
#4 |
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
![]() The coupe and hatch use the same tail lights in 86.
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
![]() |
![]() |
![]() |
#5 | |
Moderator
Join Date: Mar 2001
Location: Myrtle Beach SC
Posts: 1,643
|
![]() I changed the entire housing. ALOT easier than changing just the lenses..
Bradley Quote:
__________________
1990 GT, 347, TFS TW Heads, TFS Cam, TFS Track heat, Twin turbos, FMIC, T5. Built Ford Tough Moderator |
|
![]() |
![]() |
![]() |
#6 |
Registered Member
Join Date: Jun 2001
Location: butler pa
Posts: 303
|
![]() apon further inspection it would seem that the hatch does hang over slightly maybe 1/4 to 3/8 of an inch never really noticed before till you said something and switching just the lenses was pretty easy it took me about 1 minute per side i did the whole assembly before and it was deff more of a pita
__________________
92lx wannabe saleen |
![]() |
![]() |
![]() |
#7 |
Registered Member
Join Date: Nov 1998
Location: Kettering, Ohio
Posts: 119
|
![]() I swapped the whole housing, I think it looks fine after looking at it again. Just thought I would see what you guys thought.
![]() ![]() xspeed02 |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
96 to 98 gt with a vortech blower ,, have a question 4 you ! | southernstang97 | Modular Madness | 8 | 07-31-2002 05:52 PM |
factory alarm question for 1995 mustang gt convertible | chaos | Audio, Security, & Electronics | 0 | 07-27-2002 08:57 PM |
88 GT - rear exhaust question | Mustang_289 | Windsor Power | 3 | 09-11-2001 08:08 AM |
02 Gt or 02 Z28..that is the question. | Nick | Modular Madness | 11 | 07-16-2001 09:49 PM |
Question: '97 Mustang GT | crumbie | Modular Madness | 7 | 05-08-2001 08:39 AM |