An engine hiost is the best way to go. You'll have to unbolt your engine mounts and raise the engine enough to lower the pan untill the oil pump is almost flush with the top of the pan. Also make sure you get a one piece gasket. It seals a lot better. Hope this helps.
------------------
92' LX Hatch 5 spd, Performer Intake, 1/2" spacer, pro-m 75mm MAF, 70mm T.B., 24lb injectors, 190lph, BBK fenderwall cold air, mallary ignition & coil, 1.7 rockers, Ripper Shifter, Scattershield, Dual Friction Clutch, SVO Quadrant, Long-Tubes, Off-road H-Pipe, Pro-Dumps, Auburn Pro, 373:1, Strange Axels c-clip elims, control arms, supersubs, 50/50's, Eibach frnt drag springs, Moroso rear trick springs, no sway bar, battery in hatch, 5-Lug Pro-Stars 3 1/2", 8 1/2 26x10.5" MT ET streets, N20
9
|