Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-27-2005, 10:28 AM
|
#2 |
|
Registered Member
Join Date: Jan 2005
Posts: 10
|
Re: Roll Cage question
I think most people paint it before except for where the joints are going to be welded. The paint will just burn off anyways. Then after its welded, you have to just go inside and touch up the welded joints. As far as the cost, well that all depends on whos installing it and how many custom bend you have in it, if any. Hope this helps.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8-point competition engineering roll cage | Dog5ohfun | Windsor Power | 3 | 02-23-2004 01:34 AM |
| Roll cage install ...a few questions | Fox Body | Racer's Club House | 2 | 07-15-2002 04:41 PM |
| NHRA Legal Roll Cage? I need one! | cyberstang5.0 | Windsor Power | 2 | 05-05-2002 06:57 AM |
| Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |
| ROLL CAGE vs. NJDMV | RMARIANI | Windsor Power | 8 | 02-09-2001 06:49 AM |