Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-29-2004, 11:12 AM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
Bumpers and side skirts
I bought the Cervinis Stalker / Cobra kist a couple years ago. Since then the side skirts have split in two places, and the rear bumper ripped out of the side bolt that holds it to the body. I need to replace them but was looking to do it cheaper than the 700+ dollars it would be to go back with Cervinis. Has anyone had good luck with Design Concepts or the other companies that sell the Cobra side skirts or bumpers.
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bumpers | MustanGT | Appearance & Detailing | 1 | 05-23-2002 04:57 PM |
| How much would you pay for used 68 bumpers? | RedLilPony | Classic Mustangs | 0 | 01-28-2001 04:03 PM |