© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-26-2004, 12:28 PM | #1 |
Registered Member
Join Date: May 2003
Location: Virginia (DC)
Posts: 232
|
Clean your K&N!
All of you know this, but keep that sucker clean!! The cleaning kits are so cheap, and when it is clean, it makes a TON of difference, especially in hot and humid weather. I hadn't cleaned my in *way too long* and my car was doggin it (worse than normal ). I knew it was my filter but I couldn't find the time to clean it. Now that I realize just how much difference it made, I'll find time in the future. If your car is goin slow as hell and you don't know why.... check your filter.
Just thought I would remind you guys since it made such a difference to me. Oh yeah, I'm gonna try to get back into the board a bit
__________________
1997 Mustang GT "Pacific Green" Flowmasters Bassani X w/cats Steeda Triax K&N and Air Intake Silencer Removed More to come with money! My Ride |
08-26-2004, 06:50 PM | #2 |
Registered Member
Join Date: Dec 1999
Location: Warrington, PA
Posts: 694
|
On that note: careful when re-oilling. There are a number of people (not just Ford owners) who have blown motors because they over oil the filter. The oil then can coat the wires on the MAF, causing a bad reading and possible lean condition.
|
08-26-2004, 09:28 PM | #3 |
Mustang Fanatic
Join Date: Dec 2003
Location: Tyler, TX
Posts: 568
|
You're not jokin about cleaning your K&N. I put mine on soon after I bought the car. I saved my old paper filter so I would have something to put in while cleaning (and drying) my K&N and when I put it in it ran better with the paper air filter in it until I put the K&N back in!
__________________
Harold Phillips www.mustangsofeasttexas.org 1997 Mustang GT Convertible, 4.6L Auto, Autumn Orange w/Saddle Tan Top & Leather Interior, Styling Bar, 17 X 9 Polished Cobra R's on Nitto NT 555's, Ford Racing Bullitt Suspension package, Mac CAI, Steeda UDP's, Flowmaster 40 Series Catback, SCT X-Calibrator II, Zaino Shine, 7 time Show Winner, driven daily |
08-27-2004, 01:40 PM | #4 | |
Registered Member
Join Date: Apr 2002
Location: racine ,wi
Posts: 691
|
Quote:
I have heard and seem a car run like crap but never blow there motor
__________________
RUN IT STAIGHT AND RUN IT HARD ________ Novi 2000 60' 1.46 1/4 10.67 mph 126.5 _________ |
|
08-29-2004, 09:29 PM | #5 |
Mustangs
Join Date: Jul 2000
Posts: 1,938
|
On a daily driven vehicle (one i'd plan driving many miles) i would never own a K&N/cotton gauze filter just because of the fact that over oiling does contaminate the MAF sensor wires and because the cotton gauge filter gets dirty just as fast as a paper filter, also because it flows more air it also flows more dirt into the engine. On diesels owning a K&N filter will eventually "dust" the turbo and cause the seals to leak and the turbo looks sandblasted (Ford denies alot of warranty claims due to those filters on diesels).
MAF sensors are cleanable, but if you don't clean it, the wires could be contaminated and cause it to run lean - if you're not careful and floor it even though you hear pinging it can damage valves and pistons. To each their own, i'd rather remove the silencer, open up the airbox opening and use a paper filter on my daily driver than have to worry about cleaning the filter and MAF sensor and getting all kinds of dirt into the engine (i drive on a lot of dusty roads). I had a BBK fenderwell induction system on my GT and loved it, but i only drove that car 14,000 miles in 2 years.
__________________
2005 Suzuki Hayabusa GSX1300-R 1980 Ford Thunderbird - 255 V8 ported heads, 5.0L ported stock headers, O.R. H-pipe and Flowmaster 2-chambers, dual roller timing chain hi-po Mack Truck hood emblem 1985 Mustang GT 5.0L T5, F-303, GT40p, headers, off-road h, flowmasters, MSD stuff, etc. Sold 02/06/04 1989 Mustang GT ET: 13.304@102.29 mph (5-24-03) Sold - 1998 Mustang Cobra coupe, 1/4 mile - street tires: 13.843@103.41 (bone stock) |
08-29-2004, 09:50 PM | #6 | |
Registered Member
Join Date: Apr 2002
Location: racine ,wi
Posts: 691
|
Quote:
I have owned 4 mustangs and 2 of them hit over 160k on the motor with over 75k on one of them being with a k&N and no problems(just change your oil every 3k)
__________________
RUN IT STAIGHT AND RUN IT HARD ________ Novi 2000 60' 1.46 1/4 10.67 mph 126.5 _________ |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cleaning K&N Filter... | Bob98GT | Modular Madness | 11 | 08-07-2002 06:17 PM |
How to clean cooling system??? | Fostang | Windsor Power | 1 | 07-15-2001 06:13 AM |
Miracle clean for inside of polished Aluminum rims!! | Fox Body | Appearance & Detailing | 2 | 03-08-2001 06:42 PM |
How 2 Clean this dirty engine compartment | QuantumMotorsports | Windsor Power | 6 | 01-27-2001 02:55 PM |