advice on an eaton m-90 on a 5.0
 

OK, I just picked up an eaton m-90 for cheap and was looking for a conversion kit to put it on my 5.0 mustang. I could really use some help with where to find one.

Re: advice on an eaton m-90 on a 5.0
 

You could hand build it, but the M90 was to small when BBK made one for the 5.0 so you would have the same problem.

Re: advice on an eaton m-90 on a 5.0
 

No one makes a kit anymore. BBK's used to be based of the M-90, but I am not sure what the Snout length was on it. I am pretty sure it was a lot shorter than the M-90's found on T-Birds and GTP's. You could try getting the Kenne Bell Pipework and use it. I have seen people do that with M-112's off of Cobras and Lightinings, but not sure about the M-90's