MustangWorks.com : Ford Forums - View Single Post

danjmorris · 02-24-2001, 07:15 PM

I recently put on a Vortech mass air flow. in the box it came with to wires which look like they have resistors inside. They have blue conectors to splice into wires. I'm pretty sure they are for lowering or raising the vovltage somewhere, but not sure where. When i am driving it the check enging light comes on when I hit about 70 mph and doesn't go off till I turn off the car and then it comes on again at about 70 mph. Please help me find to where to put these wires.

Please help..

------------------
95 Yellow Mustang
Trick Flow R upper and lower intakes
Trick Flow Heads
TFS Cam
30 lb injectors
NX 150 hp kit w/ bottle warmer
255 lph intank pump
BBK 70mm throttle body
73mm Vortech Mass air
BBK Fuel Press Reg.
Borla side exhaust
Off road x-pipe
etc.etc.etc.

[This message has been edited by danjmorris (edited 02-24-2001).]

02-24-2001, 07:15 PM	#1
danjmorris Registered Member Join Date: Feb 2001 Location: Langley, B.C. Canada Posts: 1	Vortech mass air flow I recently put on a Vortech mass air flow. in the box it came with to wires which look like they have resistors inside. They have blue conectors to splice into wires. I'm pretty sure they are for lowering or raising the vovltage somewhere, but not sure where. When i am driving it the check enging light comes on when I hit about 70 mph and doesn't go off till I turn off the car and then it comes on again at about 70 mph. Please help me find to where to put these wires. Please help.. ------------------ 95 Yellow Mustang Trick Flow R upper and lower intakes Trick Flow Heads TFS Cam 30 lb injectors NX 150 hp kit w/ bottle warmer 255 lph intank pump BBK 70mm throttle body 73mm Vortech Mass air BBK Fuel Press Reg. Borla side exhaust Off road x-pipe etc.etc.etc. [This message has been edited by danjmorris (edited 02-24-2001).]