Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-30-2004, 03:19 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Hampton, Virginia
Posts: 227
|
Compression
I am going to be building a 351W blown for my 1980 Mazda RX-7. It's kinda of a Ford. I'm going to be using a Dart block and all Trickflow components from the crank on up so it will be a solid platform. I just am not sure on what compression ratios I should use. I want between 600-800 hp without nitros. I know it can be easily achivable with this setup. I haven't picked out a blower because I wasn't really sure whch one to select with all the different boost settings.
Also is a blower any better than a turbo cahrger? What are the pros and cons between them? Thanks
__________________
1980 RX7 with 289 Ford V-8 bored .030 over, Very radical cam, Torker 2 high rise intake, Holley 650 Carb, MSD Nascar 6ALN ignition, MSD coil and distributor, Headers with dual open side exhaust. Over 300 horse. 1966 Mustang still in progress |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| increasing compression ratio | 84LX89GT | Windsor Power | 6 | 11-14-2003 10:40 AM |
| #1 @ TDC on compression stroke? | 302 LX Eric | Windsor Power | 1 | 09-23-2003 04:19 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Need help!...no compression in 6 and 7!! | bobtodd | Windsor Power | 6 | 09-13-2002 03:09 PM |
| high or low compression engines | Mustangboy89 | Windsor Power | 6 | 01-26-2001 03:04 PM |