Ive seen it two ways...
1) BBK used to sell a kit that mounted a M-90 (Not sure if a M-112 would fit) on the passanger side down low and had the pipework feed up into the throttle body. This kit is now gone and I am not sure if they make it still.
2) On ebay a while back, A guy was selling a M-112 kit. It was basicly all the pipework that comes with a Kenne-Bell, except it used a Eaton M-112. I would bet you could buy just the pipework from Kenne-Bell and use a 112 that you get. I cant imagine the pipework being over $1000. So if you got the 112 for cheap enough, you prolly could get everything you need for under $1500. I had put a lot of thought in doing this myself, but I went with the Turbo setup instead.
|