![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Guest
Posts: n/a
|
![]() I just installed a bottle warmer for my nitrous system. I started warming up the blanket last night, but my pressure gauge wouldn't go over 700psi. no matter how much I increased the adjustment. Right now I have the bottle warmer solenoid thing screwed onto the nitrous bottle...then the nitrous pressure gauge...then the nitrous line. I was wondering if I need to put the gauge before the bottle warmer solenoid maybe? Swap the way I have it right now? But if the gauge is reading pressure at all, then it seems like the system should be working fine. All of the wiring and connections are done correctly. I've triple checked everything. The relay clicks on when I turn the adjustment screw on the solenoid clockwise...so I know everything is hooked up as it should be. Any ideas??
|
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
![]() Never mind. I just needed to increase the heat a little more. It's all adjusted now. I shouldn't run the pressure more than 900-950psi. correct? Going to the track tonight, hoping for a new best on the juice. Being that I haven't had a bottle warmer until now...tonight might be the night!
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
adjusting valves/ stud mount?? PKRWUD? Anyone?? | Simi Stang | Windsor Power | 8 | 07-08-2003 11:43 AM |
LS1 Vette on the bottle and moded Z06 vrs WS6 on the bottle | KEVSWS6 | Stang Stories | 9 | 04-26-2002 02:48 PM |
Japans finnest on the bottle | sedanman | Stang Stories | 6 | 03-24-2002 06:57 PM |
PULLED BOTTLE OFF | 5ohCOUPE | Stang Stories | 8 | 11-14-2001 05:58 PM |
Ricers on the bottle | QuantumMotorsports | Stang Stories | 22 | 03-18-2001 11:49 PM |