Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-05-2005, 03:58 PM
|
#1 |
|
Registered Member
Join Date: Oct 2004
Location: Gainesville, FL
Posts: 103
|
Tweecer tuning hyperpathetic pistons?
What are the chances of successfully tuning a boosted 302 block with hyperpathetics WITHOUT destroying the pistons? Purchasing a Tweecer, or similar tuner, is more cost efficient in the long run, but ONLY if I do not destroy the pistons. This is a stock SN95 bottom end with an ATI Procharger with a 9lb. pulley.
My plan was to purchase a Tweecer, conservatively tune the car myself, and then pay for an hour on a dyno in order to more finely improve the tuner's parameters. But this is all contingent on not blowing the motor up in the process. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trickflow pistons...stock heads?? | 7SecYaRight | Windsor Power | 0 | 10-09-2003 06:19 AM |
| pistons | Cait85GT5.0 | Windsor Power | 1 | 07-26-2003 11:29 PM |
| Largest cam in 351W without cutting the pistons (Looking at AFR185s) | Fox Body | Windsor Power | 10 | 06-15-2003 12:39 AM |
| Cutting valve reliefs into early pistons | QuantumMotorsports | Windsor Power | 11 | 05-14-2003 09:22 PM |
| Pistons for Larger Valves? | MustangChile | Classic Mustangs | 4 | 02-28-2003 01:27 AM |