Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-15-1999, 12:12 PM
|
#1 |
|
Registered Member
Join Date: Jul 1999
Location: baltimore
Posts: 99
|
timing adjuster
I tried the new Steeda timing adjuster
my car. I was disappointed with the results. I tried all kinds of combinations of gap and advance. I finally went back to 10 degrees ( stock ) and it still did'nt run well. I took it off. The car runs better w/o it. Any one else have similar problems? dan ------------------ '96 Cobra, Steeda G-Trac Stage III Suspension, K&N Filter,77mmPro-M,FMS Ceramic Coated Headers,Bassini-X Pipe, FMS Aluminum driveshaft, FMS 3.73's, Cobra R's , Firestone SZ-50 275-40x17's, Powerslot Rotors, Preformance Friction Z rated pads, Steeda Tir-Ax, Schroth Restraints, Kuhmo Victoracers(for the track). |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Steeda Timing Adjuster | XTheOwl | Modular Madness | 5 | 06-06-2003 07:38 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| AAAARGH! Steeda timing adjuster causing computer problems!!! | bark3rd | Modular Madness | 1 | 06-04-2001 08:15 PM |
| Timing adjustment with Steeda adjuster | bark3rd | Modular Madness | 5 | 05-17-2001 07:12 AM |
| Dyno results inside with timing adjuster installed | Mustang92 | Modular Madness | 7 | 02-20-2001 09:24 PM |