MustangWorks.com : Ford Forums - View Single Post - 1.6 rockers, will the stock valve cover work?

LOCASH · 02-22-2001, 02:09 PM

I have never done it but I have read about it a few times. If you are putting 1.6's on stock heads they fit but you may have to grind a bit here and there, and I am pretty sure you have to take off the shield at the bottom of the fill tube on the inside. You may want to check around to save some headaches. I am sure alot of people here have actually done it and know alot more than I do. There is also someone here with a GT-40P head website. I'd look into it.

------------------
86 GT T-tops, AOD, B&M shift kit and hammer shifter, ROH wheels, K&N, Timing,MAC headers, 2.5 off road H, 2.5 American Thunder, 87 spindles, rear disc,SS lines, BBK 1.5, poly bushings, Steeda G-trac and subs, Strut bar.
"DRIVE LIKE YOU STOLE IT!"

02-22-2001, 02:09 PM	#3
LOCASH Registered Member Join Date: Oct 2000 Location: Santa Lucia di Budoia, Italy Posts: 217	I have never done it but I have read about it a few times. If you are putting 1.6's on stock heads they fit but you may have to grind a bit here and there, and I am pretty sure you have to take off the shield at the bottom of the fill tube on the inside. You may want to check around to save some headaches. I am sure alot of people here have actually done it and know alot more than I do. There is also someone here with a GT-40P head website. I'd look into it. ------------------ 86 GT T-tops, AOD, B&M shift kit and hammer shifter, ROH wheels, K&N, Timing,MAC headers, 2.5 off road H, 2.5 American Thunder, 87 spindles, rear disc,SS lines, BBK 1.5, poly bushings, Steeda G-trac and subs, Strut bar. "DRIVE LIKE YOU STOLE IT!"