[Dark_5.0]

Ok my block is good for sure.

My Canfield heads were pulled off of a car that was running 12's and were working fine.

Here is the problem, I finally got my valve trane geometry correct and set the stud mount roller rockers, and I decided that I should go ahead and do a compression test.

I got "0" compression on all 8 cylinders. The motor turns over weird instead of a err...err.err sound the motor spin really fast and effortless like the heads are not even on it. WTF!!

If I totaly remove the rockers I barely get any compression at all.

Right now I dont have my upper intake on and when I crank the engine I can feel air blowing out of the lower intake ports.

This is weird.