Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-06-2002, 09:48 PM
|
#1 |
|
Registered Member
Join Date: Jul 2001
Location: West Bloomfield, MI
Posts: 391
|
can i do this without problems?
can i remove the tube that goes from the oil filler neck to the throttle body? well, i know i can but what is the best way to do this?
the reason i am asking is because i just bought a used 65mm throttle body and it does not have the fitting to connect that tube. it is just blocked off. i was going to drill the hole and then everything would go back together stock. what would or could result in removing it? i am going to put 1.7RR on so i have to remove the baffles in the valve cover. if that helps. thanks, adam
__________________
90 GT black/ grey leather ported GT-40 heads w/ 1.7RR, Cobra intake w/ ported lower, 24# injectors, 190LPH pump, 75mm Pro-M MAF, 65mm TB, K&N panel, BBK long tubes, Off road H-pipe, 2 ch. Flowmaster, Black magic fan, Kirban FPR, 180 deg. T-stat, 3.73's, Steeda Tri-Ax, 130 amp alt. Accell 8.8 race wires/cap/rotor, motorcraft plugs, Factory Five suspension, etc etc etc.... http://avbcon12.stangnet.com |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what if any problems with your Modular Model Gt/Cobra? | fixer | Modular Madness | 18 | 04-03-2005 09:18 AM |
| HELP: Problems after Paxton Novi 1000 install | Meatman | Windsor Power | 3 | 10-17-2002 06:03 PM |
| Sick 88 Gt Computer problems? | ziggy_2k | Windsor Power | 5 | 06-02-2002 10:33 PM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| Cooling System problems | 1973Mach1 | Classic Mustangs | 7 | 06-25-1999 10:33 PM |