MustangWorks.com : Ford Forums - View Single Post

Tony Frank · 01-15-2003, 07:30 PM

I highly doubt that you can make it fit. even with drop mounts you will run into problems with the headers goin too low. as it is my dad and i but a 351 in his 82 and we had a hard time finding headers that would fit in there. the ones we got to fit come down low to the ground at normal hieght.

and the motor sticks up pretty high im guessing if you did lower the mounts 2 inches you would still need a cowl hood.

i could be wrong though, im just giving you some things to think of.

01-15-2003, 07:30 PM	#8
Tony Frank Registered Member Join Date: Feb 2001 Location: Brooklyn originally, but Grand Rapids now Posts: 309	I highly doubt that you can make it fit. even with drop mounts you will run into problems with the headers goin too low. as it is my dad and i but a 351 in his 82 and we had a hard time finding headers that would fit in there. the ones we got to fit come down low to the ground at normal hieght. and the motor sticks up pretty high im guessing if you did lower the mounts 2 inches you would still need a cowl hood. i could be wrong though, im just giving you some things to think of. __________________ Grand Valley State University Senior Accounting and Finance Major 1985 Mustang GT 19,000 ORIGINAL miles, E-303 cam, edelbrock performer RPM intake, holley 600 cfm carb, MAC headers, windage tray, 8.8 rear end with 4.10 gears, 4"cowl hood, 5lug conversion, 04 Mach1 wheels. http://www.mustangworks.com/cgi-bin/moi-display.cgi?1501