[Stang_Gang]

here is a list of my new 351w i built for my 68 fastback. i drove it for the first time yesterday and was quite impressed. please look over the stats and give your oppinion of what kind of horsepower and torque you estimate this combo should produce.
thanks

block-1983 351w bored .030

crank-stock turned .010/.010

rods-stock

pistons-sealed power hyperutectic .030

bearings-clevlite 77

cam-comp cams extreme energy--
valve lift intake--.493/exhaust .512--
lobe seperation 111 degrese---
lobe lift intake .308/exhaust .320---
duration at .05--intake 218 /exhaust 226

heads--69 351 w ported and polished with 5 angle valve job 1.94/1.60 stainless steel chevy valves with double springs, stock hardened push rods,chevy 1.5 cast steel rockers on ARP studs and comp cams guide plates

intake---holley street dominator high rise with 2 inch spacer

carb---edelbrock 600 mech secondary (waiting on my berry grant 750 demon)

ignition---msd pro billit distributor, msd 6al, msd blaster coil, autolite 45 plugs, accel super stock wires

exhaust---holley black jack full headers, h pipe, 2 chamber flows, 2 1/2 inch exhaust with 3" crome tips.

car has power steering,a\c,and alt on it

trans--68 c4 with stage 2 b&m shift kit (no stall)

rear gears--3.00

all estamates are welcomed
this is the first engine i have ever built and i did it by myself in my garage (minus machine work on crank,block,and heads), with pointers from friends and family

pictures are
1 old motor comming out
2 new one going in
3 first start up (setting valves and putting in coolant thats the mess u see)
4 one of many build shots