SN95 spindles on an '84?

84_GT350 · 06-06-2001, 03:06 AM

Will this work? I just noticed that Baer carries their Sport system with SN95 spindles for a LOT less than the '79-'86 systems using stock spindles. Will they bolt on without any changes besides the struts? If it's pretty much a straight swap then I'd love to save around $500 using the SN95 spindles.

------------------
1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s

red82gt · 06-06-2001, 03:21 AM

I'm not sure, but I believe the ball joints are different so you are better off using the whole lower control arm from an SN-95 car, I'm not completely clear though, You'll have to switch to 5 lug because the hubs and wheelstuds are right on the spindle, not the rotor like the 79-93 cars.

06-06-2001, 03:06 AM	#1
84_GT350 Registered Member Join Date: Apr 1999 Location: Overland Park, KS, USA Posts: 1,631	SN95 spindles on an '84? Will this work? I just noticed that Baer carries their Sport system with SN95 spindles for a LOT less than the '79-'86 systems using stock spindles. Will they bolt on without any changes besides the struts? If it's pretty much a straight swap then I'd love to save around $500 using the SN95 spindles. ------------------ 1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
IFS drop spindles on 65-66?	65modified	Classic Mustangs	15	01-29-2007 06:06 AM
fox or sn95	sallen85	Windsor Power	1	03-24-2002 10:31 AM
sn95 five lug conv for a fox	chatcher	Windsor Power	1	03-09-2002 11:48 AM
4 cyl. spindles vs. V8 spindles	Coupe Devil	Windsor Power	2	02-11-2002 07:12 PM
does gt40 intake work with sn95?	daz95gt	Windsor Power	8	01-13-2001 08:20 AM

06-06-2001, 03:21 AM	#2
red82gt Sober voice of Reason Join Date: Nov 1998 Location: Kelowna, B.C., Canada Posts: 1,514	I'm not sure, but I believe the ball joints are different so you are better off using the whole lower control arm from an SN-95 car, I'm not completely clear though, You'll have to switch to 5 lug because the hubs and wheelstuds are right on the spindle, not the rotor like the 79-93 cars.