Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-13-2002, 10:21 AM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Gallatin, Tn
Posts: 1,326
|
4 cylinder V8 Part II
Gents, let me go over what we've got here.
It's the 88GT in the sig. We have narrowed it down to the sparkplugs not firing inside cylinders 1,2,6,& 8. They will fire outside of the cylinder. There is spark going to the plugs while running. It will start and idle fine. New plugs three times. New wires. New cap and rotor. Fuel pressure good. Noid light test good, so injectors are pulsing. Ground is doubled and tested good. New injectors. Timing set stock Compression test good in all cylinders. Pulled codes 22 and 14 not running, no test yet on running.. Tested TFI nodule at auto Zone 4 times, good. It will not drive much at all of the 4 cylinders, no smoke, no popping. It was an automatic but was swapped to a 5 speed, still has the stock AOD computer in it, pin #30 is taped off. Firing order is correct. This happened when we changed heads and piston rings and then put the motor back in. PLEASE help. thanks everyone! Shawn 
__________________
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rocker adjustment | zach0 | Classic Mustangs | 3 | 04-24-2004 12:28 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| 8 cylinder into a 6 cylinder engine bay....? | EclipseGST303 | Windsor Power | 8 | 10-04-2002 01:57 PM |
| 8 cylinder into a 6 cylinder engine bay....? | EclipseGST303 | Modular Madness | 1 | 10-02-2002 07:31 PM |
| Hard to locate part for 83 stang help!!! | 83stanger | Small Ponies | 0 | 03-02-1999 08:52 AM |