Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-09-2002, 10:45 AM
|
#1 |
|
Registered Member
Join Date: Jan 2002
Location: So. Florida
Posts: 22
|
73 MM C&L MAF- will this work?
I was planning on getting a C&L 73 MM MAF and 30# Injectors- Is the 73 MM MAF a drop in unit as far as installation (unbolt my stock MAF and bolt in a 73 MM MAF)? Will I have to add anything else other then the 73 MM MAF to run these 30# Injectors (electronics, etc.)? What electronics to I need to buy/add? What are the tubes I read about for the injectors- is this considered the electronics or other extra's I need to buy? Thanks,
Jeff 90 GT 89 TTA 87 GN http://www.geocities.com/MotorCity/Speedway/1780/ |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Axle from 4 banger work? | 90LxDroptop | Windsor Power | 1 | 04-01-2002 08:54 PM |
| will a 91 mass air harness work in a 88 gt? | bryan88gt | Windsor Power | 5 | 03-24-2002 12:39 AM |
| Anyone get ragged on at work for driving a Ford? | Crazy Horse GT | Blue Oval Lounge | 25 | 03-10-2002 07:26 PM |
| will this work for forced induction? | mikos chris | Windsor Power | 0 | 01-14-2001 03:05 PM |
| Need some professional advice - head work, valve springs, rockers, cam. pretty long. | AxemanZZ | Windsor Power | 15 | 01-11-2001 01:30 PM |