Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-29-2002, 10:24 AM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: Fresno, CA.
Posts: 10
|
Engine Problem
1965 Pony "A" block with T-10
Just had the heads done and installed a new cam. Valve lift .450/.474 SAE dur. 280/289 SAE timing:btc 27/abc 73/bbc 75/atc 34 Initial timing is 10 Went finger tight on pushrod plus one turn. The car runs okay but performance is worse than stock. Also, the car sounds constipated at the tail pipes. What did I do wrong? What should I check? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Please help stutering problem | Just me | Windsor Power | 10 | 10-18-2002 02:37 PM |
| Please Help !! Engine Starting Problem | Jayskee | Windsor Power | 1 | 07-23-2002 06:08 PM |
| Engine shake problem? | chris91LX | Windsor Power | 1 | 05-19-2002 05:31 PM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |