Adjust RR running or not running??
 

Will I put about 60 miles on my motor today and I can start to hear a rocker tapping. I had a hell of a time adjusting them when putting the motor together. It was like some of the lifters were solid. I think it would be a pain to adjust them with the intake on.
How did you guys adjust your rockers? They are stud mounted full roller.Thanks for the help.

------------------
Check my site for mod
www.fordmustanggt.com

the books usually say to adjust with the jam nut and lock them with the hex. if you give them a slight tightening with the jam nut and the hex after adjusting them, the jam nut will make the hex nut even tighter than you could get them with a hex key because the keys bend so easily. this should get them tight enough not to go loose again.

Anyone? Did you adjust yours running or not?

------------------
Check my site for mod
www.fordmustanggt.com

[This message has been edited by 92Rustang (edited 08-09-2001).]