Adjusting the clutch?
 

I have a five speed 89 mustang GT and the clutch is way too loose, it wont start to disengage until almost at the floor, so it does not get a chance to disengage the clutch fully (or at all almost). How do i tighten this up?? Thanks

If you are still using the stock quadrant for the clutch cable, it is most likely worn out. You can try and pulling the clutch pedal all the way up then pushing it back down a few times. This will tighten it up if it is not worn out. If it is worn, look into getting a aftermarket firewall adjustable quadrant.

Someone told me that i have to bleed the clutch and that should tighten this up... is that anything you have heard of? i thought that you can but i am not sure... thanks

nope bleeding is for a hydralic clutch yours is cable operated

Ok thanks that is what i thought at first but this guy swore it wasent, but does anyone have a picutre of what i can adjust or put on to adjust the cable? and it just stopped working it used to be tight...... thanks everyone