© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-28-2005, 10:49 PM | #1 |
Registered Member
Join Date: Nov 2000
Location: Maple Ridge B.C. Canada, The Best Place In The World
Posts: 871
|
Aftermarket Gauge Install?
I bought 2 gauges for the 95 5.0l motor i have, an electrical water temperature gauge, and an electrical oil pressure guage.
the installation instructions says i need a t fitting for the water temp. gauge and the oil pressure gauge. do i really need this or can i use the stock sensor? probably dumb questions, but ive never installed an aftermarket gauge before. thanks
__________________
1984 Bronco II, 36" Michelin Military Tires, 95 EFI 5.0, NP435 Tranny, NP208 Doubler, NP205 Transfer Case, Fill Size Solid Dana 44 Front End, WH Progressive Rate Rock Crawling Coils, Bronco 8.8 Rear, Skyjacker Softride Leafs, 5.13 Gears, Detroit Locker. Final Crawl Ratio Of 175:1 88 GT Best 60ft. 2.181 Best ET 14.350 Best MPH 98.01 ~WRECKED!!!!~ |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fuel gauge install | GhettoPop | Windsor Power | 4 | 01-23-2004 01:41 PM |
How do I install an Autometer gauge | Kamaro Killer | Windsor Power | 1 | 09-16-2002 06:36 PM |
Fuel Gauge install questions | Chipdog | Windsor Power | 0 | 08-12-2001 07:06 PM |
Oil pressure gauge install | mustangLX92 | Windsor Power | 1 | 07-19-2001 09:12 PM |
Gauge Install Questions | RB92GT | Windsor Power | 3 | 06-09-2001 03:07 PM |