Any one with a sway bar?
 

I installed a steeda rear sway bar, I notice that it is touching the back plate of the axle. I tried moving it but is F@#$%ing tight.
My question to you is does the sway bar has to touch the back plate of the axle or is it suppose to be separated from the axle.
I will appreciate any help as I am planing on removing it this weekend.
Ps. the sway bar is also adjustable.

I'm not too sure about your year but on my car the U-bolt brackets are slightly tilted back and the arms of the bar are parallel to the ground. My bar is not touching anything, only where they are mounted.

------------------
Black '89 GT, FMS wires, tune up kit, strut tower brace, KB subframes, front sway bar poly-bushings, Steeda G-brace, C/C plates, rear sway bar and sport springs, KYBs, B&M shifter, flex fan, 3.55 gears, 73mm calipers, SVO Master Cylinder and SS braided lines, Moroso Cold Air Induction.