MustangWorks.com : Ford Forums - View Single Post

Shotgun28 · 04-11-2001, 11:51 PM

Well gang, the snow is finally gone, they will be sweeping the roads soon and I am ready to install some more spring mods. THese are the next things to go on and I am looking for any pointers or thoughts you may have for me.

1) GT40 P head install

2)replacing Flowtech long tubes w/ Mac long tubes

3) Cobra intake

4) Smog pump idler

That's all for now, I was thinking while the heads are off I would slither the long tubes in, and hang tie them until I put the heads in, so all I would have to do is line them up, what do you think. The install should be a lot easier. Anything else I should replace while I am at it, with money being an issue.. Thanks.

------------------
91 LX Convertible Gray on Red B&M Shift improver kit,ASP red alum. underdrive pulleys, Richmond 3.73 gears, 1 5/8 Flowtech long tube Headers and off road h-pipe, Flowmaster 2-chamber cat-back with S.S exhaust, MSD 6A Ignition with coil,Cap and rotor, Taylor Pro wires, K&N 12" conical filter system, Jet stage 2 performance chip,GT40 P heads, looking at new exhaust, Lentech Street Terminator plus.

04-11-2001, 11:51 PM	#1
Shotgun28 Registered Member Join Date: Sep 2000 Location: New Hope MN USA Posts: 276	Any tips before I start...... Well gang, the snow is finally gone, they will be sweeping the roads soon and I am ready to install some more spring mods. THese are the next things to go on and I am looking for any pointers or thoughts you may have for me. 1) GT40 P head install 2)replacing Flowtech long tubes w/ Mac long tubes 3) Cobra intake 4) Smog pump idler That's all for now, I was thinking while the heads are off I would slither the long tubes in, and hang tie them until I put the heads in, so all I would have to do is line them up, what do you think. The install should be a lot easier. Anything else I should replace while I am at it, with money being an issue.. Thanks. ------------------ 91 LX Convertible Gray on Red B&M Shift improver kit,ASP red alum. underdrive pulleys, Richmond 3.73 gears, 1 5/8 Flowtech long tube Headers and off road h-pipe, Flowmaster 2-chamber cat-back with S.S exhaust, MSD 6A Ignition with coil,Cap and rotor, Taylor Pro wires, K&N 12" conical filter system, Jet stage 2 performance chip,GT40 P heads, looking at new exhaust, Lentech Street Terminator plus.