© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-12-2001, 11:38 PM | #1 |
Registered Member
Join Date: Oct 1998
Location: Suburban Chicago, Hanover Park
Posts: 695
|
Leak down test results.
Well I finally did my leak down test and here are the results:
Cyl 1 = 12% Cyl 2 = 14% Cyl 3 = 14% Cyl 4 = 14% Cyl 5 = 12% Cyl 6 = 11% Cyl 7 = 11% Cyl 8 = 13% It seemed to me that the leakage was coming through the valves or somewhere else in the heads, when I put my hand over the oil spout there was a slight warm breeze (I know I should have had the valve covers off but I had a brain fart). I am planning on replacing the heads by spring anyway so I'm not too concerned about that. I was told that anything better than 15% was pretty good so I figure I should go ahead with the head purchase and worry about a rebuild next year or maybe the next, depending on the next leak down test. Anyway I was wondering if anyone had any comments or advice, the numbers seemed ok to me, I was hoping they would all be around 10 or 11% but at least none are below 14%.
__________________
My Ford Club http://www.midwestfords.org/ Best time N/A 12.9 @ 107 1.711 60' 125 shot - 12.04 @ 113 1.59 60' |
12-14-2001, 02:16 PM | #2 |
Registered Member
Join Date: Feb 1999
Location: Utica, Michigan
Posts: 2,631
|
Your leakdown number sound just fine. The leakage is also not in the heads. The air you feel coming from the valve cover is just finding it's way past the piston rings (normal) into the oil pan, and up through the oil drain holes in the heads.
If you were leaking past a valve you would hear it through the throttle body if it were an intake valve, or through a tail pipe if it were an exhaust valve. My leakdown numbers were also 13-15 percent.
__________________
1988 Mustang GT stock bottom 302, C4 10.9 @ 128 with 8 psi of Novi 1000 boost!----STOLEN 1989 Mustang notchback Warmed up 306 with a Procharger. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Attn: PKRWUD: Compression Test Results | 95mustanggt | Windsor Power | 13 | 06-22-2004 07:34 AM |
Dyno Test Results | Harry | Blue Oval Lounge | 4 | 05-22-2003 08:38 AM |
PKRWUD: Fuel Pressue Test Results ?? | 95mustanggt | Windsor Power | 8 | 07-17-2002 01:11 AM |
How do I run a leak down test? | chris91LX | Windsor Power | 5 | 11-24-2001 11:23 AM |
Test Results on ECT and EEC-IV: HELP!! | 95mustanggt | Windsor Power | 4 | 09-30-2001 02:32 PM |