AUTO to MANUAL swap..NEED HELP!!

[ragtop5point8]

hello-i am looking to swap my buddies auto tranny and setup for a 5 speed setup. i am looking for some help as far as anything that i might overlook. my list of parts is as follows:

-5 speed tranny and shifter
-5 speed bellhousing
-5 speed flywheel
-the plate behind the flywheel
-pilot bearings
-5 speed starter
-pressure plate
-fork with throw out bearing
-clutch plate
-pedal assembly
-clutch cable

if there is anything i am missing please let me know. i am wondering does the tranny mount up ok or does something have to be modified.Is the wiring harness the same?and is the driveshaft yoke the same or does it need to be changed. any help would help out greatly.THANKS!!

[USMC302]

The crossmember will be different as well. You will also need wiring, Ford sells the part you need for around $20 I beleive. Also, you will need to get a 5 speed ECU, or search for PKRWD's solution to modifying the current harness. I think you may have to do both. The driveshaft will work however, it's recommended to swap, just get an aluminum and don't worry about it. Remember to fill it with ATF. Good luck.