Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-05-2007, 11:23 AM
|
#1 |
|
Registered Member
Join Date: Mar 2000
Location: minneapolis, mn
Posts: 158
|
Ball Joint Boot opinions...
Simple question....just looking for opinions
I am finishing pressing im my ball joints. I ended up with the good moog joints with the greasable fittings. Would you recommend using the moog boots or i also have Prothane boots that fit. Both are new. The moog seem to hold more grease and the Prothane seem kinda chincy but they are urthathane so they will hold up. They arent as deep as the moog covers but i dont think the goal here is to pack in tons of grease on the top of the joint more than the function of keeping dirt and shit out of the joint..... anyone?
__________________
1991 LX coupe,AOD, red, 80k, K&N, MAC cat back, MAC off-road X, Autometer Gauges, BBK Ceramic unequals, fully polished upper intake, fuel rails, and egr, working on installing.....MM full length subs, H&R sport springs, MM Lower control arms, MM caster camber plates, bilstein shocks, struts. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New spindles and the lower ball joint | bmxmon | Classic Mustangs | 6 | 08-11-2005 07:56 PM |
| ball joint replace in a 65 - how hard is it? | Steriti | Classic Mustangs | 5 | 07-03-2004 05:32 PM |
| U-joint for TH400yoke to SVO driveshaft | ultraflo | Windsor Power | 2 | 05-24-2002 06:46 PM |
| Heim joint rear end? | gtsr515 | Windsor Power | 5 | 05-15-2002 10:55 PM |
| Granada Disks Lower Ball Joint Problem (65 Mustang) | oldmustangjunkie | Classic Mustangs | 6 | 11-17-2001 03:08 AM |