You do have to raise the passenger side of the motor to install the bbk equal lenth header on the pasenger side trust me I have them.
Do not put the 1 5/8 inch bbk equal length headers on a stock engine cause they will slow your 1/4 mile down they take away alot of your back presure and you lose torque
but if you are planning on running nitrous like I am or planning on some mods later then they would be ok.
The headers look great and are a quality product the only problem that I have with them is I have about 30 runs on the headers and they are already turning all kinds of rainbow colors . (My car is not street driven)
------------------
88 mustang gt convertible bored to 306 BBk equal length headers mac cold air fender kit 3.73 FMS gears cowl hood nitto drag radials ford racing clutch flow masters h-pipe 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs.
|