Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-28-2003, 07:52 AM
|
#1 |
|
Registered Member
Join Date: Apr 2002
Location: Tustin, CA
Posts: 465
|
BBK Headers on TFS Heads.. Problem?
I bought a set of BBK ceremic headers off ebay... though BOTH headers dont quite line up with the twisted wedge heads i have... the first two tubes lines up fine but the lext two are shifted over about 1/4 inch... just enough I cant get my bolts in...
So I guess I wanted to know if anyone else had this problem, is it a BBK thing, I could seel these off i'm sure and maybe pick up a set of long tubes but am I going to have the same problem... I wanted to avoid banging them over cause the ceramic isnt very flexable and would probabaly chip off. I could probably reem out the hole but it's getting awful close to the tube.. looks liek they had been elongated before.. cause I know headers never just bolt right up -as
__________________
'89 GT Convertible: TFS TW Heads, TFS Street Intake, TFS Stage 1 Cam, FMS 1.6 RRs, 24# Injectors, Pro-M 75mm MAF, No Name CAI, 3.73s, O/R H-Pipe, FlowMasters, AOD w/ Trans-Go Shift Kit |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 71 2v Cleveland heads on a mild 302 | crazypete | Windsor Power | 3 | 06-18-2004 07:05 PM |
| Heads | Rosco | Windsor Power | 1 | 03-16-2002 09:13 AM |
| Cleveland vs. 302 | MetalHead | Stang Stories | 1 | 03-06-2002 01:48 AM |
| Anybody use the GT-40P headers on stock heads? | Scappoose | Windsor Power | 3 | 01-15-2002 06:38 PM |
| FRPP headers and AFR 165cc heads? | LowDown | Windsor Power | 1 | 01-10-2002 01:50 PM |