MustangWorks.com : Ford Forums - View Single Post

GhettoPop · 10-18-2003, 11:53 PM

well my original clutch with 118k is on her way out, god bless her soul.

1)whats a good clutch to pickup, this is a street driven stock 90 Gt but I would like a quality clutch that will launch nice and take some abuse. any ideas?

2) and i also figure i should do the following as well:
Pressure Plate
Throwout Bearing (is orig alum? should get a steel replacement?)
Pilot Bearing
Rear Main Oil Seal
change tranny fluid (redlin synthetic atf)

3) flywheel - resurface or replace? since its the orig clutch, i doubt the flywheel has ever been touched.

4) also, thinkin bout getting:
clutch cable
adj quad
firewall adjuster
- any brand preferences for the 3 and are they necessary or just a good idea? thanks in advance.

10-18-2003, 11:53 PM	#1
GhettoPop Gimme a Drink! Join Date: Dec 2002 Location: NYC Posts: 694	best clutch and setup? well my original clutch with 118k is on her way out, god bless her soul. 1)whats a good clutch to pickup, this is a street driven stock 90 Gt but I would like a quality clutch that will launch nice and take some abuse. any ideas? 2) and i also figure i should do the following as well: Pressure Plate Throwout Bearing (is orig alum? should get a steel replacement?) Pilot Bearing Rear Main Oil Seal change tranny fluid (redlin synthetic atf) 3) flywheel - resurface or replace? since its the orig clutch, i doubt the flywheel has ever been touched. 4) also, thinkin bout getting: clutch cable adj quad firewall adjuster - any brand preferences for the 3 and are they necessary or just a good idea? thanks in advance. __________________ 1990 GT,stock T-5,K&N w/o air silencer,March underdrives,FMS wires,timing@14*,PA Perf 130amp alt,Steeda Tri-Ax Shifter,Steeda adj quadrant/clutch cable/firewall adj,Centerforce II clutch,o/r x-pipe,Magnaflow SS catback,g-load brace, subframes,Bilstein struts/shocks,Autometer gauges, 136k and running strong!