Block Question

rj_stang · 02-05-2001, 11:22 PM

I just finished the disassembly of my 351W. I have it down to the bare block. Upon taking it apart found that two rods are shot. It also appears that one of the rods nicked the cyl. There is a little part missing off the wall of the cyl. By the wear it appears that it is about 3/4 of an inch past bottom of the piston stroke. How much of a problem will this be and is it reparable without skirting the cyl?

elmir50 · 02-07-2001, 02:08 AM

If the damge is near the bottom of the hole or at the bottom it shouldn't be much of a problem. How bad is it? Will a overbore clean it up? I have a 302 that had a similar problem. There was a bit of material at the bottom of one of the holes that was damaged but it was still good because it was not in the pistons travel. If you are still unsure then ask a engine builder.

02-05-2001, 11:22 PM	#1 (permalink)
rj_stang Registered Member Join Date: Jan 2001 Location: Villa Park, IL Posts: 36	Block Question I just finished the disassembly of my 351W. I have it down to the bare block. Upon taking it apart found that two rods are shot. It also appears that one of the rods nicked the cyl. There is a little part missing off the wall of the cyl. By the wear it appears that it is about 3/4 of an inch past bottom of the piston stroke. How much of a problem will this be and is it reparable without skirting the cyl?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Big Block swap	Sage427	Modular Madness	2	09-29-2004 09:49 PM
Need help deciding on an engine block!!	93 Cobra needs input	Windsor Power	6	10-23-2002 06:29 PM
351 Marina block buildup?	Agent_4573	Windsor Power	3	06-30-2002 10:38 AM
What makes a Small block a Small block and a Big Block a big block?	gtsr515	Windsor Power	13	05-20-2002 11:25 PM
86 block / E7 head question	302man	Windsor Power	5	11-13-2001 08:27 PM

02-07-2001, 02:08 AM	#2 (permalink)
elmir50 Registered Member Join Date: Mar 1999 Location: Tsawwassen BC Canada Posts: 413	If the damge is near the bottom of the hole or at the bottom it shouldn't be much of a problem. How bad is it? Will a overbore clean it up? I have a 302 that had a similar problem. There was a bit of material at the bottom of one of the holes that was damaged but it was still good because it was not in the pistons travel. If you are still unsure then ask a engine builder.

Sponsored Links