Bolt sizes for tranny swap
 

does anybody know the bolt sizes/length for all the components needed for an aod/tremec tranny swap. flywheel, flex plate, bellhousing, etc. just thinking having the right bolts on hand will make the job a little bit easier. thanks, also, i see the aod to t5 conversion, is the tremec 3550 about the same?

this is for a 93 gt 5.0 thanks

When I switched out my AODE to the Tremec in my 95 the only thing I needed was different flywheel bolts and for some reason, with a Mcloud blow proof bellhousing different tranny to bellhousing bolts. I think Tremec supplies 7/16" bolts but I ended up needing 1/2". Also I had to very carefully open the bolt holes in the mounting ears of the Tremec. I think that I had to trim a piece off the case of the tranny but I dont remember why.