Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-02-2003, 08:12 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Woodlawn IL,USA
Posts: 62
|
Brake Problems
I have been having a lot of problems with my front brakes locking up when I jam on them. I changed pads recently, and I checked the back pads and I had NO OR VERY LITTLE WEAR ON THEM. I wanted to know if there is a proportioning valve in the system that may have went to sh*t or something. If not, how do I put in a proportioning valve and where/ what kind do I use? Install info?
HELP!!!! I am tired of do the "white knuckle dance" every time I hit the brakes. Thanks, Brad
__________________
GTNBY2 getin' by 2!! 351W, 30 over, Comp Cams XE274h, Trick Flow Street Heat intake, AFR185 heads, 70mm TB, 80mm Mass, 24lb inj, Moroso cold air kit, BBK 1 5/8" unequal length headers, 2 1/2" off road X-pipe, 40 series Flowmasters |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| brake problems ??? | Rodoggx | Windsor Power | 2 | 04-27-2004 04:54 AM |
| Brake problems | 84GT350-1 | Windsor Power | 1 | 12-28-2003 08:02 PM |
| Brake Problems | arivera | Small Ponies | 3 | 04-24-2003 04:02 PM |
| Rear disk brake conversion problems | BLOCKER | Windsor Power | 6 | 04-02-2001 06:10 PM |
| Brake Problems | ddawson | Corner Carvers Delight | 1 | 02-03-2000 08:39 AM |