Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-15-2005, 12:02 AM
|
#1 |
|
Registered Member
Join Date: Jun 2002
Location: manassas, va
Posts: 186
|
Upper Control Arm Bushing
I am getting ready to install my BBK upper control arms. With it, came some bushing that go into the rear. I believe they are polyurethane bushings that I have to replace my stock rubber ones. I have never replaced these bushings before. Any advice on removing the old ones and installing the new ones?
__________________
1983 mustang, 393 cubic inch stroker small block, victor jr heads and intake, gold race 1.6 roller rockers. comp cam 304, 244@ .050. .576" hydralic retro roller cam,lunati rods. block was o-ringed,10:1 forged pistons, speed pro fit fit rings, clevite bearings,msd distributor and igniton,be cool huge radiator, black lite electric fan, march underdrive pulleys, mildon deep sump oil pan, mac 1 3.4" long tube headers, 3" dr gas x-pipe and mac exhaust,ARP bolts. car weighs 2900 lbs w/out driver, sub frames, weld wheels, mickey thompson sportsman pro 26 x 10.5 x 15's,#8 fuel line steel braided |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Upper control arm bushing | glxstang | Windsor Power | 0 | 09-10-2001 12:57 PM |
| Steeda heavy duty upper control arm | Yan88gt | Windsor Power | 0 | 08-09-2001 06:35 PM |
| REAR UPPER AND LOWER CONTROL ARMS | bcinyuz | Windsor Power | 1 | 05-08-2001 04:17 AM |
| south side lift bars & upper control arm questions | BowTie Eater 5 Liter | Windsor Power | 3 | 01-28-2001 05:39 PM |
| Rear upper control arms | red82gt | Corner Carvers Delight | 2 | 08-01-2000 11:10 AM |