C-6 In Foxbody With A 351w?!?!
 

ok so here's what happened, i'm doing a 351w swap into a 93 coupe, now I have a c-6 tranny for it but they say it wont work, tranny is to long, have to cut driveshaft, now I really dont wanna do that, are they just bullshitting me or will this tranny fit? if not i'm just going to get a c-4

Re: C-6 In Foxbody With A 351w?!?!
 

id recommend a c6 if you were driving a truck ...otherwise id go with a c4 - you would be much happier

Re: C-6 In Foxbody With A 351w?!?!
 

ok, so if i go with the C-4 will it mount up right and will it fit in there without any driveshaft modifications? I have the aftermarket cross-member for the true dual exhuast and the cross-members arent welded to the bushing housing yet so its still front to back adjustable. and i'm going with solid motor and transmission mounts

Re: C-6 In Foxbody With A 351w?!?!
 

im not sure on the driveshaft length as i havent done it myself ...somebody else will have to tell you that one or ..there is a neat little search button - you could try using that

Re: C-6 In Foxbody With A 351w?!?!
 

im running a c4 and could measure the drive shaft for you.

Re: C-6 In Foxbody With A 351w?!?!
 

I'm running a C6 bolted right in like was made for it. Yes you will need a shorter drive shaft

Re: C-6 In Foxbody With A 351w?!?!
 

well i'm pretty sure it will fit but i just wanted to know if the stock driveshaft would work, i mean by the splines on the tranny yoke, and also what the difference is on the 4 cyl and 5.0 mustang driveshafts, they look the same but i dont know if the splines are the same

Re: C-6 In Foxbody With A 351w?!?!
 

Splines should be the same