Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-30-2002, 12:40 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
C&l
Ok, I've tried to ask this question like 3 times but only 20 people have viewed all three threads combined. Is there anyway to tell what size sample tube a 76mm C&L mass air meter has in it? Or any way to test it?
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Full dyno testing on the C&L Plenum, 75mm TB, C&L MAF | 91LX2Bfast | Modular Madness | 4 | 01-23-2004 07:09 PM |
| cobra?? IMRC/ injectors and C&L | mellow98cobra | Modular Madness | 1 | 07-18-2003 11:18 AM |
| Should I add a cold air system to the C&l meter? | v8thunder | Modular Madness | 5 | 06-23-2003 01:40 PM |
| C&L Clear sampling tube? | Falcons Talon | Windsor Power | 2 | 05-08-2003 08:14 AM |
| C&L install | OMAR | Windsor Power | 0 | 04-22-2003 11:32 PM |