12-09-2003, 08:23 AM
| #1 (permalink) |
| Registered Member Join Date: Jan 2000 Location: Mount Joy, PA , U.S.
Posts: 193
|  Cam Clearence I was wondering can any one tell me if a .516 lift on my cam will work with stock heads stock pistons, but crane valve springs. Also where can I find a bolt kit for a Eldlebrock performer intake. Thanks |
|      |
|
12-09-2003, 10:49 AM
| #2 (permalink) |
| Sniffed too much n20 Join Date: Oct 1998 Location: Ont, Canada
Posts: 1,018
| It should... should... No guarantee unless you check. Usually the duration makes the difference in P/V clearance issues. For example, I'm running 1.90/1.60 valves with a cam of 224* Intake, 232* Exhaust (at 0.050") and lift is .542" / .563". I had to clearance the notches only slightly to make it work properly. Hope that helps.
__________________ 2002 Windsor Weekend Q16 Qualifier |
|
| |
|
12-10-2003, 07:09 PM
| #3 (permalink) |
| Registered Member Join Date: Jan 2001 Location: ny
Posts: 197
| dur. is needed to decide if it will clear or not. your lift is fairly low so you should have no problem assuming your heads havent been milled alot. the springs have nothing to do with p/v clearance. as for bolts, intake bolts are intake bolts. they dont make special bolts for certain intakes. |
|
| |
| Sponsored Links | |
| | |
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| valve clearence? | srv1 | Windsor Power | 21 | 07-25-2002 10:26 PM |
| wheel base clearence | 87 GT MUSTANG | Windsor Power | 1 | 04-28-2002 07:10 PM |
| Piston to valve Clearence?!?!? | kenneth kimble | Windsor Power | 6 | 03-01-2001 09:41 PM |
Linear Mode
