noise in rear
Ok fellas here we go, I installed a set of D&D adjustable upper rear controll arms and now sometimes when I go over bumps I get this rattling/clunking noise. At first I thought it was the upper part of the controll arm moving and smacking a bolt that was too small for the hole, wrong. Next thing I did was crank the bolts down hard, I actually broke a socket doing this, still there. Next I checked the exhaust pipes for smacking on the car, found a few spots and fixed those up nicely, noise is still there. Next was tighten all brackets in the back and check for cracked or pulling away torque boxes, all look good and all brackets have been retightened, noise still there. Im at a loss on this one, im starting to think that its the shocks or u-joints but I want some oppinions here, so thanks in advance.
__________________
**MODERATOR AT WWW.COLORADOSTANGS.COM**
Cobra upper and lower intake, bbk 70mm throttle bodie, mac cold air kit,
bbk/walbro 190lph fuel pump, pro m 75mm bullet mass air meter, jet computer chip, bbk lowering springs (1.5"), D&D adjustable upper rear controll arms, Indexed spark plugs,
gripp caster/camber plates, under drive pullys, msd 6al ignition, msd blaster coil, taylor 10.5mm plug wires, bassani exhaust with an x, saleen ceramic headers, 3:73 gears, E-303 cam,1.6 roller rockers, aeromotive adjustable fuel pressure regulator, cobra r clutch, 180 thermostat, manual fan on/off switch (high), msd shift light, autometer volt, water and air/fuel carbon fiber, everything inside car, white faced guages, hurst pro 5.0 shifter,
Pro-M Remote Optimizer
And finally a new trans so now I can race again
Next up, some suspension work.
**Working on traction issue**
1/4 mile- 14.85@91mph at 5800ft above sea level
60'- 2.12
1/8 mile 9.52@72mph
Just some fyi, my times would be about this at sea level:
1/4 mile- 13.6
60'-1.8 or 1.7
1/8 mile- 8.2
|