Car doesn't seem to transfer power to the wheels quick enough after letting offclutch
 

Just as the title says guys. I'm wondering if my clutch is toast. It only has about 20k miles on it, it probably didn't have a chance against my driving style. Or maybe the Clutch Quadrant needs to be replaced or? I have no idea. It only happens when I'm starting from a stop, when I downshift while rolling it engages perfectly. Maybe the tires are spinning and not squealing so I can't tell? Any opinions would be great.

------------------
Team Xspeed Leader/Co-Founder
1990 Black Mustang GT 5spd
Current Mods: 2 1/2 Offroad H-Pipe, Borla Cat-Back Exhaust, 91-93 5 Star Pony Wheels, K&N Filter, Free Mods, Pioneer Headunit, MB Quartz Speakers, Orion Xtreme 300 Amp, 2 JL Audio W0's, 130 Amp Alternator, 3.73's
Future Mods: Engine rebuild with Trickflow Heads, GT-40 Intake, Custom Ground Cam, and 14lb ATI Procharger!
AIM=xspeed02



[This message has been edited by xspeed02 (edited 04-14-2001).]

If your tires where spinning you should feel rear end of car loosen up some. I would put in a billet quadrent and adjustable cable. See if this helps. 20k is that much on a clutch. The new quad and cable will be cheaper then a new clutch. And any ways its a good upgrade from stock setup. Hope its not the clutch. As thats a blown saturday.

------------------
Amsoil dealer, find out about amsoil's preferred customer program, buy at dealer cost.

Yah its definitely not tire spinning, I just mentioned that as to not to rule out everything. I was racing Saturday night and my clutch slipped bad when I shifted into 2nd. I'm hoping its just the quadrant. Thanks for the info.

------------------
Team Xspeed Leader/Co-Founder
1990 Black Mustang GT 5spd
Current Mods: 2 1/2 Offroad H-Pipe, Borla Cat-Back Exhaust, 91-93 5 Star Pony Wheels, K&N Filter, Free Mods, Pioneer Headunit, MB Quartz Speakers, Orion Xtreme 300 Amp, 2 JL Audio W0's, 130 Amp Alternator, 3.73's
Future Mods: Engine rebuild with Trickflow Heads, GT-40 Intake, Custom Ground Cam, and 14lb ATI Procharger!
AIM=xspeed02

DONT RULE OUT THE CLUTCH CABLE,IT COULD BE BINDING OR STRETCHING.