car wont start!!

50bird · 08-09-2001, 06:42 PM

The other day I shut my car off went inside to get something and when I came back out it wouldn't start. When I turned the key, it was if the I hadnt egaged the clutch before starting. I bybassed the the clutch saftey, and it still didn't start. I replaced the starter relay, still wont start. The only way I get the car to start is if I cross the relay terminals with a screwdriver. I tested for voltage at the relay and got 12v which is good but I dont know why it won't start. Could it be a bad ignition module??? I dont have msd or any aftermarket system. If the ignition module is bad would it be wworth it for me to buy 6Al anyway. Any tips on what it could be, Thanks.

PKRWUD · 08-09-2001, 06:53 PM

It's not your ignition module. If you can start it by crossing the posts on the relay, and you know the relay is good, then the relay isn't getting a signal from the key. Could be the ignition switch or the clutch switch, but since you bypassed the clutch switch, I would lean towards the ignition switch. First verify that the relay trigger wire is not getting any voltage when the key is turned to the start position. If it's not getting any, then look into the ign. switch.

As far is getting an MSD, unless your car was built in the 1980's, your factory ignition system is as good, if not better. Fords capacitive discharge ignition systems were standard when MSD was still analog! Certain modifications justify spending the money on an aftermarket box, but usually the owner knows it by the time they get there. List your car info, including year and mods, in your signature, and then people can offer advice more suited to you specifically.

Take care
~Chris

------------------
Retired Moderator
MustangNet

My site: JimPorterRacing

RACECAR spelled backwards is RACECAR

HEY !!! Are you ASE Certified ??? If you are, ask me about iATN. The best tool you'll ever have, and it's free !!!

08-09-2001, 06:42 PM	#1 (permalink)
50bird Registered Member Join Date: Aug 2001 Location: phila pa 19111 Posts: 2	car wont start!! The other day I shut my car off went inside to get something and when I came back out it wouldn't start. When I turned the key, it was if the I hadnt egaged the clutch before starting. I bybassed the the clutch saftey, and it still didn't start. I replaced the starter relay, still wont start. The only way I get the car to start is if I cross the relay terminals with a screwdriver. I tested for voltage at the relay and got 12v which is good but I dont know why it won't start. Could it be a bad ignition module??? I dont have msd or any aftermarket system. If the ignition module is bad would it be wworth it for me to buy 6Al anyway. Any tips on what it could be, Thanks.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wont Start, help! 1995 GT 5.0	Year2001Boogie	Windsor Power	13	05-05-2004 10:26 PM
Wont Start, Dies, Help ! 1995 GT-5.0	Year2001Boogie	Modular Madness	8	04-29-2004 03:12 PM
EEC does not energize unless key turned to start	crazypete	Windsor Power	23	09-20-2002 10:00 AM
sometimes car turns over a lot but doesn't start	MineralGray02K	Modular Madness	3	09-16-2002 11:41 PM
HELP- CAR WONT START	jimdrechsler	Windsor Power	12	06-29-2001 09:44 PM

08-09-2001, 06:53 PM	#2 (permalink)
PKRWUD Junior Member Join Date: Mar 1999 Location: Ventura, California Posts: 8,981	It's not your ignition module. If you can start it by crossing the posts on the relay, and you know the relay is good, then the relay isn't getting a signal from the key. Could be the ignition switch or the clutch switch, but since you bypassed the clutch switch, I would lean towards the ignition switch. First verify that the relay trigger wire is not getting any voltage when the key is turned to the start position. If it's not getting any, then look into the ign. switch. As far is getting an MSD, unless your car was built in the 1980's, your factory ignition system is as good, if not better. Fords capacitive discharge ignition systems were standard when MSD was still analog! Certain modifications justify spending the money on an aftermarket box, but usually the owner knows it by the time they get there. List your car info, including year and mods, in your signature, and then people can offer advice more suited to you specifically. Take care ~Chris ------------------ Retired Moderator MustangNet My site: JimPorterRacing RACECAR spelled backwards is RACECAR HEY !!! Are you ASE Certified ??? If you are, ask me about iATN. The best tool you'll ever have, and it's free !!!

Sponsored Links