vibrating clutch pedal

fel0n10us · 08-31-2001, 10:43 AM

ok i have a 96 gt it just had a clutch replaced and now the pedal is vibrating. it does it more so in lower gears and will sometimes make a pop pop pop noise when braking to stop and in gear. i have tried restting the clutch to no avail

anyone have any ideas?

thanks

cvenom96 · 08-31-2001, 11:43 AM

Mine does the same thing and did so from the start. I think there is a service bulletin about it but I'm not sure of the Ford solution.

------------------
96 Crystal White Cobra Coupe
4:10 gears, off-road h-pipe, 2 chamber flowmasters, K&N, pulleys, FMS springs, polyurethane bushing, Steeda Caster/Camber plates

fel0n10us · 09-01-2001, 07:43 AM

http://www.corral.net/forums/showthr...014#post100014

i found the answer

cvenom96 · 09-01-2001, 08:30 AM

I wondered if that was it. I just had to change mine about 3 months ago and it is already squeaking again. It sucked getting the transmission out because it's bolted to the bellhousing from the inside.

08-31-2001, 10:43 AM	#1
fel0n10us Registered Member Join Date: Aug 2001 Location: Ridgeland, MS USA Posts: 12	vibrating clutch pedal ok i have a 96 gt it just had a clutch replaced and now the pedal is vibrating. it does it more so in lower gears and will sometimes make a pop pop pop noise when braking to stop and in gear. i have tried restting the clutch to no avail anyone have any ideas? thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Clutch pedal to high?	Scrapla	Windsor Power	5	08-15-2004 12:16 PM
'65 - Pull Away Problems - Action Plan	geordie	Classic Mustangs	0	05-14-2002 01:43 PM
4cyl clutch pedal vs 5.0 pedal?	WADS56	Windsor Power	5	02-05-2002 02:27 AM
Clutch pedal and steering questions...	richd	Windsor Power	2	12-19-2001 10:59 AM
billed 5 times to install clutch by Pauls Auto, please read and give opinions (long)	beefcake	Blue Oval Lounge	2	02-23-2001 03:05 PM

08-31-2001, 11:43 AM	#2
cvenom96 Registered Member Join Date: Aug 2001 Location: Madison, MS Posts: 52	Mine does the same thing and did so from the start. I think there is a service bulletin about it but I'm not sure of the Ford solution. ------------------ 96 Crystal White Cobra Coupe 4:10 gears, off-road h-pipe, 2 chamber flowmasters, K&N, pulleys, FMS springs, polyurethane bushing, Steeda Caster/Camber plates

09-01-2001, 07:43 AM	#3
fel0n10us Registered Member Join Date: Aug 2001 Location: Ridgeland, MS USA Posts: 12	http://www.corral.net/forums/showthr...014#post100014 i found the answer

09-01-2001, 08:30 AM	#4
cvenom96 Registered Member Join Date: Aug 2001 Location: Madison, MS Posts: 52	I wondered if that was it. I just had to change mine about 3 months ago and it is already squeaking again. It sucked getting the transmission out because it's bolted to the bellhousing from the inside.