MustangWorks.com : Ford Forums
Page 2 of 2 1 2
Show 50 post(s) from this thread on one page

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   cobra intake (http://forums.mustangworks.com/showthread.php?t=46026)

bailey_57 05-10-2005 11:09 AM
Re: cobra intake
 
i ran 14.5 with 2.2 60ft time, no traction at all and the rear is screwed. i am waiting for it to quit before i tear it out. stock everything except 373's 65mmTB full exhaust and kirban adj fp reg

88workcar 05-10-2005 09:26 PM
Re: cobra intake
 
Get a set of 4 cyl springs for the front, ditch the sway bar, try to get some 90/10s and that 2.2 will go away.

bailey_57 05-11-2005 01:31 PM
Re: cobra intake
 
88workcar, did you reuse head bolts or buy new, i've never installed heads before.

Simi Stang 05-11-2005 07:48 PM
Re: cobra intake
 
Quote:
Originally Posted by bailey_57
88workcar, did you reuse head bolts or buy new, i've never installed heads before.
I'm not 88workcar...but I'll jump in anyway. No, do not reuse the same head bolts. New heads deserve new head bolts.

Simi Stang 05-11-2005 07:51 PM
Re: cobra intake
 
Quote:
Originally Posted by 88workcar
Get a set of 4 cyl springs for the front, ditch the sway bar, try to get some 90/10s and that 2.2 will go away.
Do you think my car could benefit from 4 cyl. springs in the front? I have stiff, specific rate Eibach lowering springs on all 4 corners right now. Would the 4 cylinder front springs keep it lowered some still? And would the 4 cyl. springs be ok for street driving? Going around turns, over bumps, etc.?


All times are GMT -5. The time now is 07:42 AM.
Page 2 of 2 1 2
Show 50 post(s) from this thread on one page