© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-02-2001, 10:11 AM | #1 |
Registered Member
Join Date: Dec 1999
Location: chicago,IL,USA
Posts: 158
|
Question 4 Anyone Running Welds?
I'm switching to 5 lug Pro-Stars w/ 3 1/2 front and 15 x 8 1/2 back with 15 x 5 1/2 back spacing. Do I need to run spacers in the front or back?
------------------ 92' LX Hatch 5 spd, Performer Intake, 1/2" spacer, pro-m 75mm MAF, 70mm T.B., 24lb injectors, 190lph, BBK fenderwall cold air, mallary ignition & coil, 1.7 rockers, Ripper Shifter, Scattershield, Dual Friction Clutch, SVO Quadrant, Long-Tubes, Off-road H-Pipe, Pro-Dumps, Auburn Pro, 373:1, Strange Axels c-clip elims, control arms, supersubs, 50/50's, Eibach frnt drag springs, Moroso rear trick springs, no sway bar, battery in hatch, 5-Lug Pro-Stars 3 1/2", 8 1/2 26x10.5" MT ET streets, N20 9 |
05-04-2001, 03:38 PM | #2 |
Registered Member
Join Date: Apr 2001
Location: Gallatin, Tn
Posts: 1,326
|
Don't know muc about backspacing but am running the same rims on my 88 coupe with no spacers and they are fine. Hope this helps.
------------------ 88LX NOTCH, 88GT, 95 GT. |
05-05-2001, 12:48 AM | #3 |
Registered Member
Join Date: Jun 2000
Location: ventura,CA
Posts: 438
|
You won't need any spacers just get the backspacing correct. I have 15x4 and 15x8 centerline convo pros on my 92 and I fit a 28x10.5 MT tire with no problems. I had to roll the fender to get ample clearance, it's a daily driver. It even cleared the quad shocks.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Another tire question | 96Saleen | Modular Madness | 6 | 02-10-2004 05:27 PM |
Valvetrain Question | 306bullet | Windsor Power | 1 | 09-11-2003 07:48 PM |
A stupid question I hate asking about exhaust sound | jwboner | Windsor Power | 4 | 08-05-2003 05:55 PM |
Distributor question | physicusstang | Windsor Power | 1 | 10-23-2001 12:57 PM |
Question for those running Victor 5.0 intakes | 8850 | Windsor Power | 1 | 01-08-2001 05:26 PM |