Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-06-2002, 03:52 PM
|
#1 |
|
Registered Member
Join Date: Oct 1998
Location: Suburban Chicago, Hanover Park
Posts: 695
|
Comp. Engineering D/S Safety loop ?'s
It sure doesn't look like this thing is going to fit too well with the new FRPP aluminum drive shaft. Looks like there will be about a milllimeter ot two between the bolts and the d/s, and I'm a little woried about that d/s spinning at high speeds that close to the bolts. Anybody running the Competition Engineering Drive Shaft Safety Loop with an alum d/s? Any tips on how I can make this work without worrying about it?
Thanks, Chris |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Safety Issue 64 - 70 Mustangs | Mach1 Cobra Jet | Classic Mustangs | 20 | 07-11-2005 08:06 PM |
| O2 codes at open loop? | Nixon1 | Windsor Power | 6 | 04-24-2004 08:43 PM |
| Comp Cams | burn rubber | Modular Madness | 2 | 08-29-2003 12:09 AM |
| driveshaft safety loop install? | Simi Stang | Windsor Power | 16 | 02-12-2003 07:45 PM |
| Bad News...blown clutch safety switch | Stang_ROTY | Windsor Power | 1 | 05-31-2002 08:49 PM |