computer swap?

Chipdog · 01-06-2001, 01:01 AM

Can I run a A9L computer from a 89 5 speed in my 92 AOD? What problems will it have if any?

------------------
92 GT Convertible
K&N, Hooker Headers, H-Pipe, Flow Masters, B&M Holeshot 3k converter, 4.10s, BBK 1.5 drop, 73mm Vortech Mass air, 65 FMS TB, B&M Super Cooler trans cooler, FMS Aluminum radiator

And a Small Blow Job

LOCASH · 01-06-2001, 05:04 AM

I had the same question. Here is what I found in one of Isaac Martin's book-
"...The reason is that the AOD transmisssion has a starting system connection in which, when the key is ON, in the START position, 12 volts are fed to pin 30 in the ECU connector plug. you can put the auto ECU in a manual transmission , since it doesn't miss the signal. If you install a manual transmission ECU in an AOD application that 12 volt power will fry the ECU."

------------------
86 GT T-tops, AOD, B&M shift kit and hammer shifter, ROH wheels, K&N, Timing,MAC headers, 2.5 off road H, 2.5 American Thunder, 87 spindles, rear disc,SS lines, BBK 1.5, poly bushings, Crutchfield front kick panel speakers.

01-06-2001, 01:01 AM	#1
Chipdog Registered Member Join Date: Apr 1999 Location: Miami,Fl USA Posts: 297	computer swap? Can I run a A9L computer from a 89 5 speed in my 92 AOD? What problems will it have if any? ------------------ 92 GT Convertible K&N, Hooker Headers, H-Pipe, Flow Masters, B&M Holeshot 3k converter, 4.10s, BBK 1.5 drop, 73mm Vortech Mass air, 65 FMS TB, B&M Super Cooler trans cooler, FMS Aluminum radiator And a Small Blow Job

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
94-95 to 89-93 computer swap?	LX XLR8R	Windsor Power	14	06-26-2003 03:20 PM
will this computer work with engine swap	Chevysucks	Windsor Power	1	10-11-2002 10:29 AM
computer swap for a 94 cobra	mak375	Windsor Power	19	05-06-2002 12:51 AM
swap 95 computer for 89-93	sn95gt19	Windsor Power	3	04-01-2002 01:29 AM
Computer swap in 94 cobra	mak375	Windsor Power	4	11-24-2001 02:37 AM

01-06-2001, 05:04 AM	#2
LOCASH Registered Member Join Date: Oct 2000 Location: Santa Lucia di Budoia, Italy Posts: 217	I had the same question. Here is what I found in one of Isaac Martin's book- "...The reason is that the AOD transmisssion has a starting system connection in which, when the key is ON, in the START position, 12 volts are fed to pin 30 in the ECU connector plug. you can put the auto ECU in a manual transmission , since it doesn't miss the signal. If you install a manual transmission ECU in an AOD application that 12 volt power will fry the ECU." ------------------ 86 GT T-tops, AOD, B&M shift kit and hammer shifter, ROH wheels, K&N, Timing,MAC headers, 2.5 off road H, 2.5 American Thunder, 87 spindles, rear disc,SS lines, BBK 1.5, poly bushings, Crutchfield front kick panel speakers.